Trinco Dry Blast Abrasive Media
TRIN MIXES:
Trinco’s exclusive combination of glass bead and aluminum oxide delivers fast and efficient cutting action while maintaining close tolerance and a fine satin finish. With three grades to choose from, one will be the solution to your cleaning/finishing application.
TRIN-MIX # 4:
The finest of the Trin-Mixes, Trin-Mix # 4 is ideal for removing light to medium contamination from tools, tooling, molds and dies. It is considered a general purpose media which can be used in a wide range of applications from texturing plastic injection molds to providing appealing finishes on exposed stainless steel and aluminum surfaces. Dimensional change of less than .001 inch can be expected.
TRIN-MIX # 2:
Somewhat more aggressive than Trin-Mix # 4, Trin-Mix # 2 promotes faster cleaning and a slightly rough finish. Ideal for heavier contamination where a dimensional change of minus .001 inch is acceptable.
RAD-MIX:
This is the most aggressive of the Trin-Mixes. Although developed for the radiator rebuilding industry, it is ideal for removing tough contamination from surfaces with a minus .001 inch tolerance or better.
TRIN-BLAST ALUMINUM OXIDE:
The fastest abrasive for general blasting, dimensional changes of .001 to .002 may occur.
Guaranteed First Quality Virgin Grain meets ANSI standard B74.12-1976, Military Standard A21380-B. Consistent, resistant to breakdown, very low iron content.
NUT SHELLS:
Soft aggregate used in removal of foreign matter or coatings from surfaces without etching, scratching or marring cleaned areas. Applications include delicate molds, armatures and electric motors prior to rewinding.
SILICON CARBIDE:
Extremely hard but friable abrasive used in blasting, grinding and polishing very hard materials, i.e. granite, ceramics, glass, marble. May be used on soft resilient plastics. Meets ANSI standard B74.12-1976
TRIN-BEADS GLASS BEADS:BT
Ideal for removing foreign matter from workpiece, without removing base metal, changing dimensions, contaminating parts or overstressing.
COARSE – BT # 3 & 4:
Good for cleaning heavier contamination and peening for stress.
MEDIUM COARSE BT # 5, # 6, & # 7:
Good for engine rebuilding, mold texturing, and peening of softer metals.
MEDIUM – BT # 8, # 9, # 10:
Good for plating, anodizing preparation, and most general applications.
FINE – BT # 12 & # 13:
Good for cleaning light contamination and wherever a fine surface finish is desired.
For more info, visit www.p65warnings.ca.gov.
