Starrett V-Blocks and Clamps 568C
52592
Starrett V-Blocks come in a variety of styles to suit the numerous requirements of machinists. They are for general shop use and layout work, as well as for holding stock in place during light-duty milling, drilling, and grinding operations. All clamp screws have a hole to help secure the workpiece. V-Blocks (2) and Clamps (Matched Pair)
Features
- Hardened steel, precision ground parallel and square
- V-grooves are ground central and parallel to the sides and base - perfect alignment in matched pairs
- Clamps have screw holes at 45º and 90º to hold either square or round work
- Stepped groove construction permits high or low clamp mounting or small or large work
- Clamps do not project over the width of the block, permitting it to be used on the base, ends or sides
- 3/8-16 tapped holes permit mounting blocks on faceplates or angle irons
- Each block is 2-1/2" long x 3" wide x 2" high (63 x 75 x 50mm)
Specifications
- Capacity (in): 2" Dia. Round; 1-7/16" Square (1-9/16" with Screw at Top)
- Capacity (mm): 50mm Dia. Round; 36mm Square (40mm with Screw at Top)
For more info, visit www.p65warnings.ca.gov.
