Omega Drill Broken Tap Removal Drill OD-1/8 - OMR-002
Brand: Omega Drill- SKU:
- OMR-002
- ID:
- 89863
| Removes Sizes | #8, #10, #12, M4, M5 |
Omega Drill Broken Tap Removal Drill OD-1/8
Use For Tap Sizes: #8, #10, #12, M4, M5
Features:
- Removes even the most stubborn Broken Taps.
- Revolutionary carbide grade and advanced drill point geometry.
- Works on spiral flute, straight flute and forming taps.
How to use:
Step 1:
Remove as much as practical of any uneven broken top surface of the tap, creating a reasonably flat surface for the Omegadrill to drill into.
Step 2:
Clamp the part securely. Use as large a diameter Omegadrill as possible to spot the broken tap. Drill at 1,200 to 2,500 RPM on a rigid and stable machine tool such as a machining center or knee mill.
Step 3:
Using the recommended size Omegadrill, drill down through the broken tap. Drill dry or use straight cutting oil – not coolant. Peck the drill and flush chips out frequently with an air blast. Best results are achieved with using light quill hand feed on a knee mill. When reaching the bottom of the broken tap, a slight vibration will be felt. It is best to stop drilling at this point, to minimize any risk of damage to the Omegadrill’s cutting edges.
Step 4:
Using either a scriber, or the picks and pin vise supplied with the Omegadrill set, remove the remnants of the broken tap flutes.
For more info, visit www.p65warnings.ca.gov.
