iGaging Router Table with Lift & Caster
*Router NOT included. (Please select a DeWalt or Bosch Router we list below)
- A new featured-filled router table package with more included "extras" than any other table on the market
- All this system needs is a router with a (standard) 3-1/2" body, and you'll be good to go.
Included in the Package 50-200&C:
- A sturdy Steel Frame with leveling feet. It's fast and easy to assemble. Notice the four lower frame bars waiting for you to build a shelf or a cabinet to hold your bits and router tools.
- The Tabletop is a full-sized 31-1/2" x 23-3/4" by 1-1/2" thick with a smooth laminate surface. The combination T-track and miter track, plus parallel T-tracks for supporting the fence, are installed and ready to use.
- A Split-face Fence so you can narrow or broaden the gap between the faces to get the best dust collection and provide the safest operation.
- A Zero Clearance Insert minimizes tear-out (it's easy to make as many extras as you need – plans included.)
- A Bit Guard that keeps your fingers safe.
- An On/Off Switch simultaneously turns your shop vac and router on and off. It comes with a removable "key" to prevent router access when you're not around.
- A solid extruded Aluminum Fence includes a dust port, ruler tape, and T-tracks both in front and on top
- A pair of 1/4" Aluminum Bars that shift the left fence forward from its standard location to let you use the router table as an edge jointer. You can set the face offset to be either 1/16" or 3/32" out from the right fence.
- A Flip-Stop that enhances safety and consistency in repetitive work. Unlike some flip-stops, this one is ridged and doesn't wiggle.
- TWO Feather Boards to provide steady constant pressure against the wood. Use the two side-by-side or one above and one by the side.
- A rigid Aluminum Router Plate and Router Lift system with a lift lock eliminates fumbling under the table for bit changes and adjustments. The lift can adjust the height of the router bit in 0.001" increments. Since each rotation of the graduated dial is .05", it is easy to convert to fractions (five rotations equals 1/4")
- FIVE different Insert Rings to ensure you have the right one for any size bit. (including a wire wrench to remove or lock the rings.)
- A Starter Pin to leverage the wood into the bit's cutting edge when free-hand routing against a bearing bit. The router top has THREE locations to insert the start pin so you can select the best location for your needs.
- A four-page Assembly Manual and an eleven-page Operational and Safety Guide.
- Router NOT included.
For more info, visit www.p65warnings.ca.gov.
