GS Tooling CAT50 1-1/4" x 3.94" Shrink Fit Holder w/ Coolant Ports - 541-960

GS Tooling CAT50 1-1/4" x 3.94” Shrink Fit Holder w/ Coolant Ports - 541-960 

• Unsurpassed Accuracy: Concentricity of ≤.0001” (3μm) with tool shrunk in holder.
• Coolant Ports: Each holder has 4 coolant ports in the nose to ensure coolant gets right to the tool.
• Max Gripping Torque: Tool is gripped 360° along the entire length of bore producing very high gripping torque, preventing chatter.
• Increased Production: Decrease down time - the total time elapsed to remove one cutting tool and insert another is less than 10 seconds.
• Balanced: GS follows the strictest balance standards. Our holders are pre-balanced G2.5 up to 30,000rpm
• Extended Holder Life: With double tempered tool steel construction, reduced centrifugal forces, minimized bore contamination, and minimized chatter, a GS Shrink Fit Toolholder should far outlast a standard end mill holder.
• Chip load distributed evenly along cutting edge of tool which results in longer tool life
• Short projections are possible because no mechanical clamping devices are used. This results in greater rigidity and resistance to bending.
• Since Shrink Fit toolholders have no moving parts they offer the greatest repeatability of any tool holding system on the market.

For More GS Tooling CAT50 Shrink Fit Holders w/ Coolant Ports Click Here