Edge Pro Tram System with Calibration Gage & Padded Case, 1/2" Shank Size, 0.001" Graduation - 01-000
Brand: Edge Technology Tool- SKU:
- 01-000
- ID:
- 113554
| Shank Size | 1/2" |
| Graduation | 0.001" |
$149.95
Edge Pro Tram System with Calibration Gage & Padded Case, 1/2" Shank Size, 0.001" Graduation - 01-000
Features:
- Tramming is the process of squaring the head of your mill to the table. Most machinists know that if your mill is not trammed properly surface finishes will be poor and parts will not be flat or square.
- The patent pending Pro Tram by Edge Technology solves all of these problems allowing you to tram your mill quickly and accurately.
- To use the Pro Tram simply lower the unit down onto the table and adjust the head until both indicators read the same number. Repeat this process for the opposite axis and you are done.
- The Pro Tram is also sized perfectly to fit the bed of a 6 inch vise allowing you to tram the head to the vise instead of the table.
See all versions of the EDGE PRO TRAM SYSTEM with Calibration Gage & Padded Case
For more info, visit www.p65warnings.ca.gov.
- For more information about the characteristics of the review control, the possibility of contacting the author of the review, the time frames for publication and retention of reviews, as well as the methods of deleting or modifying reviews, please check our Terms and Conditions.
- No consideration has been given in exchange for the reviews, with the exception of reviews marked ‘Incentivized & Verified’, for which the verification procedures are available from here.
- Names marked by an * have been pseudonymized as requested by the author.
-
VerifiedCollected and verified by Verified Reviews
-
VerifiedCollected and verified by Verified Reviews
-
VerifiedCollected and verified by Verified Reviews
-
VerifiedCollected and verified by Verified Reviews
-
VerifiedCollected and verified by Verified Reviews
- 1
- 2
